Product

Rate

PHI*

Comments

Dibrom

• Do not apply when temperature is over 32°C, application in hot weather may cause crop injury.
• Also controls loopers.
• Do not enter treated area for 48 hours.

Lagon 480 E

• Apply when aphids are first detected, at least 3 weeks after transplanting.
• Do not apply more than 3 times per season.

Orthene 75 SP

• Apply when insects reach economic threshold levels but do not apply more than 4 times per season.
• Do not irrigate crop for at least 48 hours after application.
• Do not apply if rainfall is expected within 48 hours of application.
• Do not enter treated area for 1 day. For activities involving significant foliar contact, gloves and cotton coveralls must be worn for 2 weeks.

Assail 70 WP

• Also controls pea leafminer using the high rate.
• Thorough coverage is important.
• Repeat at 7 day intervals.
• Do not use more than 5 times per season.
• Do not apply more than 300g/ha (121g/acre) per season.
• Do not re-enter treated areas for 12 hours.

Admire 240 F

Post-transplant
field drench:
6.0 mL per 100 mL row

(see Rate Conversion Chart of label for row spacing calculations)

• Use one of the following methods:
• Apply specified dosage in 2000 L/ha (800 L/ac) of water as a narrow (5 cm or less) surface band over the seedline during planting.
• Seedlings or established transplants: apply in 200 L/ha (80 L/ac) of water as a subsurface side-dress on both sides of each row. Product must be incorporated into the root zone.
• Post-seeding drench or transplant-water drench: use higher water volumes to thoroughly wet the soil
• Do not apply more than once per season.
• Do not follow with any subsequent foliar application of a group 4 insecticide.
• Do not re-enter treated area for 24 hours.

Actara 240SC

• Make an in-furrow application at the seeding or transplant depth or a narrow surface band above the seedline during planting.
• For a surface application, incorporate to the seeding depth with irrigation within 24 hours after planting.
• Do not apply more than 625 mL/ha (253 mL/acre) per year.
• Do not follow with any subsequent foliar applications of of a group 4 insecticide.
• Do not re-enter treated area for 12 hours.
• Also controls dipteran leafminers.

Actara 25 WG

• Maximum of 2 foliar applications per season.
• Repeat at 7 day intervals.
• Do not use if following an in-furrow or soil application of Actara 240 SC.
• Highly toxic to bees.  Do not apply or allow to drift onto blooming crops or weeds if bees are foraging in or adjacent to the treatment area.

Closer SC

• Do not use in greenhouses.
• Do not make more than 2 applications per growing season.
• Repeat at a 7 day interval.
• Do not apply more than 300 mL/ha (120 mL/acre) per growing season.
• Do not apply during crop flowering period or when flowering weeds are present in treatment area.
•  Observe a plantback interval of 30 days for crops not on this label. 
• Do not enter treated area for 12 hours.

Sivanto Prime

500 to 750 mL/ha
(200 to 300 mL/acre)

• Do not use in greenhouses. 
• Repeat at a 7 day interval.
• Do not exceed a total of 2000 mL/ha (810 mL/acre) of product per season.
• Do not use in the greenhouse.
• Toxic to bees.  Do not apply if flowering weeds are present and bees are visiting the treatment area.
• Do not enter treated areas for 12 hours.

Fulfill

• Maximum of 2 applications per season.
• Apply at a 7 day spray interval.
• Observe a 30 day plant back restriction for all crops.
• Do not enter treated area for 12 hours.
• Apply with a non-ionic adjuvant such as: Agral 90, Ag Surf, LI 700, or Sylgard 309 to improve performance under drought conditions.

Malathion 85E

• Do not make more than 1 application per year.
• Best control is obtained when temperature is above 20° C.
• Do not apply after expiry date on the container label.
• Do not re-enter treated area for 24 hours.

Movento

• Repeat at 7 day intervals as needed.
• Maximum allowed per crop season: 730 mL/ha (295 mL/acre).
• Do not enter treated area for 12 hours.
• Use with one of the following adjuvants: non-ionic (eg. Agral 90 or Ag-Surf) or methylated seed oil (eg. Hasten).

Exirel

500 to 1500 mL/ha
(200 to 605 mL/acre)

Apply in 100 L/ha (40 L/acre) of water

• Also controls cabbage looper and leafminer.  See sections of this table.
• Do not make more than 4 applications per growing season.
• Repeat at 5 day intervals.
• Do not apply more than 4.5 L/ha (1.8 L/acre) per season.
• Use with an adjuvant such as Hasten NT at a rate of 0.25% v/v or MSO Concentrate with Leci-Tech at a rate of 0.5% v/v.
• Toxic to bees and certain beneficial insects.  Apply early in the morning or late in the evening when bees are not active.
• Note:  Do not tank-mix or apply in sequence with strobilurin-, copper- or captan-containing fungicides.
•  Observe a plantback interval of 30 days for legume vegetables, cereals, grass, crop group 1A (inlcuding beets, carrots, radish, parsnip, turnip) and crop group 2 (inlcuding beet greens and turnip greens). 
• Observe a plantback interval of 1 year for crops not on this label.
• Do not enter treated area for 12 hours.

Beleaf 50 SG

• Repeat at 7 day intervals.
• Do not apply more than 3 times per year.
• Do not apply more than 480 g/ha (200 g/acre) of product per season.
• Do not re-enter treated area for 12 hours.

Sevin XLR

• Maximum of 2 applications per year.
• Repeat at a 7 day interval.
• Use lower rates on young plants.
• Apply when insects and damage appear.
• Toxic to bees. Avoid applying when crop is in bloom.  If it is necessary to apply during crop bloom, make applications during the evening to avoid foraging bees.
• Do not enter treated area for hand-harvesting, hand-pruning or irrigation for 5 days.  Do not re-enter for hand-weeding or thinning for 12 hours.  

Delegate WG

•  
• For optimal performance, final solution pH should be in the range of 6 to 8.
• Apply at egg hatch or to small larvae.
• Maximum of 3 applications per year.
• Toxic to bees. Avoid spraying when bees are foraging.

Success 480SC

• Maximum of 3 applications per year.
• Repeat at 7 to 10 day intervals.
• Do not apply immediately after rainfall or if rainfall is expected with 48 hours of application.
• Do not re-enter treated areas until spray deposit has dried.

Entrust 80 W

• Do not apply more than 3 times per year.
• Repeat at 7 to 10 day intervals.
• Do not apply when winds exceed 16 km/h.
• Do not re-enter treated areas until spray deposit has dried.
• Highly toxic to bees exposed to direct treatment, drift or residues.  Harmful to parasitoids and predatory mites.  Slightly harmful to foliage-dwelling predators.
• Entrust products are OMRI-USA listed.  Check with your certiification body before using in an organic operation.

Entrust SC

XenTari WG

• Controls loopers only.
•  Treat larvae at the early instar stage.
• Repeat at 5 to 7 day intervals.
• Use enough water to ensure full coverage but not to the point of run off.
• Larvae must be actively feeding on treated, exposed plant surfaces.
• Apply in the evening or on a cloudy day.
• Do not allow spray mixture to stand in the tank for more than 12 hours.
• Xen Tari products are OMRI-USA listed.  Check with your certiification body before using in an organic operation.

Bioprotec CAF

• Also controls loopers.
• Most effective when pests are young.
• Must be eaten by caterpillars.
• Use sufficient spray volume to ensure uniform coverage on all plant surfaces.

Intrepid

• Controls cabbage loopers only.
• Apply at first sign of feeding damage.
• Repeat at 7 to 14 day intervals.
• Do not re-enter for 12 hours.

Coragen

• Registered to control cabbage looper.
• Repeat at 3 day intervals.
• Do not make more than 4 applications per season.
• Do not enter treated area for 12 hours.

Exirel

250 to 500 mL/ha
(100 to 200 mL/acre)

Apply in 100 L/ha (40 L/acre) of water

• Controls cabbage looper only.
• Also controls aphids and leafminer.  See sections of this table.
• Do not make more than 4 applications per growing season.
• Repeat at 7 day intervals.
• Do not apply more than 4.5 L/ha (1.8 L/acre) per season.
• Toxic to bees and certain beneficial insects.  Apply early in the morning or late in the evening when bees are not active.
• See aphid control comments (this table) for tank-mix precautions and plantback intervals.
• Do not enter treated area for 12 hours.

Agri-Mek 1.9% EC

• Use Agri-Mek SC with a non-ionic surfactant at the rate of 0.1 to 0.5% v/v of spray mixture. 
• Apply in 200 L/ha (80 L/acre) of water.
• Repeat at 7 day intervals.
• Do not apply more than 4 times per season.
• Do not apply to transplants.
• Highly toxic to bees. Avoid spraying when bees are foraging.
• Check labels for re-entry intervals.

Agri-Mek SC

Citation 75WP

• Apply at first appearance of larvae.
• Re-apply as needed, allowing at least 7 days between applications.
• Do not make more than 5 applications per season.
• Do not enter treated area for 12 hours.

Coragen

• Repeat at 3 day intervals as needed.
• Do not make more than 4 applications per season.
• Do not apply more than 1 L/ha (400 mL/ac) per season.
• FOR CONTROL OF BLACK CUTWORM, use the lower rate and apply to smaller plants or when lower portions of the plant can receive adequate coverage.
• Do not re-enter treated area for 12 hours.

Exirel

1000 to 1500 mL/ha
(405 to 605 mL/acre)

Apply in 100 L/ha (40 L/acre) of water

• Controls larvae.
• Also controls aphids and cabbage looper.  See sections of this table.
• Do not make more than 4 applications per growing season.
• Repeat at 5 day intervals.
• Do not apply more than 4.5 L/ha (1.8 L/acre) per season.
• Use with an adjuvant such as Hasten NT at a rate of 0.25% v/v or MSO Concentrate with Leci-Tech at a rate of 0.5% v/v.
• Toxic to bees and certain beneficial insects.  Apply early in the morning or late in the evening when bees are not active.
• See aphid control comments (this table) for tank-mix precautions and plantback intervals.
• Do not enter treated area for 12 hours.